V2000-c Rfid Access Control User Manual !full! Jun 2026

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring

Features an anti-tamper alarm and built-in buzzer. 2. Technical Specifications Operating Voltage: 12V DC (usually 12V-24V DC or AC) Card Type: 125kHz EM RFID Card/Fob Reading Distance: 3-6 cm Lock Output Load: Max 3 Amp Environment: -20°C to 60°C (-4°F to 140°F) 3. Installation Guide (V2000-c)

Do you need to connect an or door bell?

| Key | Function | Programming Steps | | :--- | :--- | :--- | | | Change System Password | Press 1 → Enter 5-digit new password (e.g., 88888) → Device beeps to confirm | | 2 | Add User (Card OR PIN) | Press 2 → Enter 4-digit User ID → Present Card OR enter 6-digit PIN → Device beeps | | 0 | Add User (Card AND PIN) | Press 0 → Enter 4-digit User ID → Present Card → Enter 6-digit PIN → Device beeps | | 3 | Delete User | Present Card OR enter 4-digit User ID of target user → Device confirms deletion | | # | Exit Programming Mode | Press # to return to normal standby state after finishing settings | V2000-c Rfid Access Control User Manual

Before mounting or wiring the unit, ensure your installation environment meets the physical and electrical operating criteria of the V2000-c keypad: Specification Up to 2,000 users (Cards/PINs) Operating Voltage 12VDC ±10% (Supports 24VAC systems on select variants) Card Read Type 125kHz EM (Identification) / Proximity Cards Card Read Distance Card Read Speed Less than 0.1 seconds Relay Output Load Max 3A (Supports Fail-Secure and Fail-Safe locks) Interface Input/Output Wiegand 26 (Can function as an external reader) Built-in Security Tamper switch sensor and door status alarm Installation and Wiring Diagram Physical setup of the Go to product viewer dialog for this item.

: Alarm Output (ALARM) – Triggers external siren on forced entry Initial Setup and Programming Mode

If you need the specific section regarding programming the or the Wiring Diagram , let me know and I can provide the generic steps for this model. The V2000-C is a single-door multifunction standalone access

Release the button after hearing a series of short beeps. The Master Code reverts to factory defaults. 6. Troubleshooting Common Issues Potential Cause Recommended Action No power supply output

Before powering up the system, verify the power supply is and ensure correct polarity connections.

If you forget the system password or need to restore factory settings, follow these steps: Installation and Wiring Features an anti-tamper alarm and

Always turn off the main power supply before handling any electrical wiring. Wiring a Fail-Safe Lock (Magnetic Lock) Connect the power supply to the V2000-C +12V .

Are you using an or a simple 12V adapter?

Use the provided security screwdriver to remove the back housing from the keypad.

If you can tell me (magnetic or strike), I can tell you exactly which wiring diagram you need to follow. RFID Programming Guide

Connect an exit push button to the designated input terminals. Pressing the button activates the relay without requiring credentials.